Jerry glare panels for fiberglass, since the unfair competition and price wars and other reasons, glare shield, many manufacturers produce glare shield current raw materials have changed from the original fiberglass SMC material change BMC cheap material. BMC resin and glass fiber content lower than the SMC, the same size and thickness of the glass plate steel glare, glare board schematics, BMC's strength a lot worse, too. HDPE blow molding material for use in anti-glare panel, the main way to reduce costs is to add fillers such as calcium carbonate or recycled material inside the masterbatch. However, the addition of such fillers, wind load strength high-speed anti-glare panel glare shield is greatly reduced. Construction Requirements: shading angle glare shield spacing settings, glare height, plate width and plate shall conform to the drawings. Glare shield in front of construction, should determine the control point, distance between control points located at the stakeout. Glare panels in the construction process, must not damage the central reserve communication channels and railings. Drawings should be required to deal with anti-glare sheet on a good road and bridge position and height, without distortions and rugged appearance. When the anti-glare panel alone embedded column, only after the foundation concrete to meet the design strength grade, before installation of the upper member. Anti-glare panel glare shield effect _ _ power safety equipment provided by the Xinxiang County Economic Development Zone power safety equipment operators. Xinxiang County Economic Development Zone power safety equipment operators (www.xxlmdgs.com) strong, credible, anti-collision facilities in Xinxiang industry has accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead power safety equipment and you hand into the brilliant, for a better future!