In the transport and production of innovative design, many companies have done a lot of useful exploration, of which there are two far-reaching exploration. A blow molding process is applied to the anti-glare panel production, production cross section of pit-shaped plate, made of HDPE antiglare plate. Another would molded fiberglass craft, which is later called SMC material applied onto the anti-glare panel. Glass steel sheet at a high temperature, high pressure molding, an inverse S-shaped cross-sectional structure, wind strength significantly enhanced, and later in most fiberglass glare panels have adopted this form. Change the structure of the cross section parameters glare panel glare shield, our highway scientists invented a "people" shaped structure, which greatly enhances the effect of wind load glare panel. Herringbone structure of the most stable, supporting the largest standard anti-glare panel, this structure would glare shield, the lower one into two, change "foot stand" to "both feet", the entire anti-glare panel formed after the installation of the fence is stable triangular support structure. Triangular structure of the most stable, then a big wind are not afraid. Glare panels wholesale power safety equipment (certified), Sichuan glare shield provided by the power of Xinxiang County Economic Development Department safety equipment operators. Xinxiang County Economic Development Zone power safety equipment operators (www.xxlmdgs.com) is an industry leader in Shenzhen, Guangdong, crash facility, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, and satisfy customer needs . Safety Equipment leadership in power with the staff warmly welcome all inquiries negotiations to create power safety equipment a better future.